Advertisement
D9131A
Event Description and Troubleshooting
Event
Fire
Supervision
Fire
Supervision
Restoral
Fire Trouble
Fire Walk End
Fire Walk Start
Forced Close
Forced Point
Late To Close
Late To Open
Log Overflow
Log Threshold
Missing Alarm
Missing Fire
Missing Trouble
Msng
Supervision
No Entry -
Level
No Entry -
Interlk
No Entry -
Secured
No Entry -
Unknown
Opening Report
Params Changed
Peri Dlay Armed
Peri Inst Armed
Phone Line Fail
Phone Restoral
Point Bypass
Point Closing
Point Opening
Point Status
Point Tested
Prog Access Ok
Pt Bus Trouble
Pt Bus Restoral
Ram Access Fail
Ram Access Ok
Re-Boot
Relay Reset
Relay Set
Request To
34584G
Description
Supervision condition at the fire point specified.
Supervision condition at the fire point specified has been restored.
Trouble condition at area device specified.
Walk test* for fire devices in the area specified is complete.
A walk test* is in progress for fire devices in the area specified.
User with reported ID armed area with point(s) faulted.
User force armed device in area reported.
User with reported ID armed the security system later than expected.
User with the reported ID disarmed area later than expected. If the entire security system is
being disarmed, the previous state of the system is indicated. If just one area is being
disarmed, no previous state is indicated.
Security system event log is full. Events are being overwritten.
Security system event log is at the programmed maximum capacity.
Device in area specified is not reporting. Call for service.
Fire device in area specified is not reporting. Call for service.
Trouble Condition at area device specified.
Supervision device at area specified is not reporting.
An access card holder attempted access but was denied due to the user's authority level.
Access was denied due to the interlock door being open.
Access was denied due to the door being secured.
Access was denied because the user was not found in the database.
User with reported ID disarmed area.
Security system programming has been changed.
User with ID reported armed the perimeter of the specified area with delay time.
User with reported ID armed the perimeter of the specified area with no delay time.
The phone line specified is not working. Call for service.
The problem with the phone line specified has been restored.
Area device specified is bypassed.* System will not respond to faults at this device.
User armed device in area specified.
User disarmed device in area specified.
Status report for device in area specified.
This device has been walk tested.*
Account has been accessed locally by the device specified.
Wiring problem. Call for service.
Wiring problem is resolved.
Technician could not access your security system from the security company.
Your security company accessed your system from the security company.
Your security system was reset.
Relay has reset.
Relay specified has been turned on.
A Request To Enter device for an access door has been activated.
D9131A User's Guide
Page 6
© 2002 Bosch Security Systems
Advertisement
