Qlogic Fibre Channel Switch Event Message Manual page 21
Firmware version 5.0
Hide thumbs
Also See for QLogic Fibre Channel Switch:
- Event message manual (86 pages) ,
- User manual (56 pages) ,
- Quick start manual (8 pages)
Table of Contents
Advertisement
A
(A1004.0029) (No Switch capable of being Principal Switch. Reconfigure Principal Switch
Priority.)
Meaning:
Action:
(A1004.002B) (Port
port_number
to connect to remote switch)
Meaning:
Action:
(A1004.002D) (Non-interop Legacy switch setting prevents domain/port zoning)
Meaning:
Action:
(A1004.002F) (Request for Domain ID rejected, WorldWide Name (WWN)
allowed to join fabric.)
Meaning:
Action:
(A1004.0030) (Topology change, lost route to switch with domain ID
Meaning:
Action:
(A1004.0032) (E_Port not supported on remote port. Reconfigure remote switch to
connect.)
Meaning:
Action:
(A1004.0033) (Remote switch is in Interop mode or using Legacy Address Format)
Meaning:
Action:
59060-01 B
An E_Port isolated because the principal priority on all switches is
set to 254.
Configure one of the switches to be the principal switch by
changing the principal priority.
not configured for E-Port capability, reconfigure to G/GL
An attempt was made by a remote switch to connect through a port
that could not configure itself as an E_Port.
Change the port type on the remote switch to G_Port or GL_Port.
Zone members involving switches of other vendors cannot be
defined by domain ID and port number when Interop Mode is
disabled and Legacy Address Formatting is enabled.
Disable (False) the Legacy Address Formatting, enable Interop
Mode, or reassign the zone members using a method other than
domain ID and port number.
The switch with the specified worldwide name is not allowed to join
the fabric.
Add the switch to a group in the active security set.
Connection was lost to a switch in the fabric.
Inspect switch connections and device hardware for proper
operation. Review accompanying alarms for other causes.
An E_Port isolated because the port on the remote switch could
not configure itself as an E_Port.
Change the port type on the remote switch to G_Port or GL_Port.
A remote switch is attempting to connect with conflicting settings
for Interop mode or legacy address format.
Configure the switches so that Interop mode and Legacy Address
Format settings are the same throughout the fabric.
3 – Event Messages
Alarm Events
not
device_WWN
)
domain_ID
3-9
Advertisement
Table of Contents
