Advertisement
Quick Links
AM-FM
STEREO
TUNER
BASIC IT
INSTRUCTION
MANUAL
For your records
Record the serial number, found on the back of the-unit, in
the spaces
designated
on the warranty
card, and in the
space provided below.
Refer to the model and serial num-
bers whenever you call upon your KENWOOD
dealer for in-
formation or service on this product.
Model BASIC T1 Serial Number
Unpacking
Unpack the unit carefully and make sure that all accessories
and cables are put aside so they will not be lost.
Examine
the
unit
for
any
possibility
of shipping
dam-
age.
If your unit is damaged or fails to operate, notify your
dealer immediately.
If your unit was shipped to you directly,
notify the shipping company
without delay.
Only the con-
signee (the person or company receiving the unit) can file a
claim against the carrier for shipping damage.
We recommend that you retain the original carton and pack-
ing materials for use should you transport or ship the unit in
the future.
installation precautions
a) Avoid locations subject to direct sunlight.
b) Avoid high or low temperature extremes.
c) Keep the unit away from heat radiating sources.
d) Choose a location that is relatively free of vibration or ex-
cessive dust.
e) Make sure power is off before making any system con-
nections.
WARNING:
TO PREVENT FIRE OR ELECTRIC SHOCK, DO
NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
KENWOOD
Important!
U.S.A. and Canada
Units shipped to the U.S.A. and Canada are designed
for operation on 120 volts AC only. These units are
not equipped with an AC voltage selector switch and
the discussion of such a switch that follows should be
disregarded.
All other countries
Units
shipped
to countries
other than
the
U.SA,
Canada and U.K. are equipped with an AC voltage se-
lector switch on the rear panel. Refer to the following
paragraph for the proper setting of this switch.
AC voltage selection
This unit operates on 120 volts or 220-240 volts AC. The
AC
voltage
selector
switch
on
the
rear
panel
is set
to the voltage that prevails in the area to which the unit is
shipped. Before connecting the power cord to your AC out-
let, make
sure
that
the setting
position
of this switch
matches your line voltage.
If not, it must be set to your vol-
tage in accordance with the following direction.
Note: —————_____——
——— ——__—c—
Our warranty does not cover damage caused by excessive line vol-
tage due to improper setting of the AC voltage selector switch.
220-240Vv
120V ~
220-240V ~
Setting
1-1
Setting
AC voltage selection (Fig. 1)
1. Before
plugging
in this unit, make
sure that the po-
sition of the AC voltage selector conforms to your line
(mains) voltage.
If not, it must be reset. See Figure 1-1.
2. To reset the selector, slide the stopper plate to the oppo-
site side with a screwdriver or other pointed tool.
See
* Figure 1-2.
3. Insert the power cord securely. See Figure 1-3.
PRINTED IN JAPAN B50-4826-00 (K, P) (G)
©
7890N/354 D12345/454
Advertisement
