Download Print this page

caddytrek R2 Replacement

Hide thumbs Also See for R2:

Download this manual

Tools Needed:

• Phillips screwdriver or

• 3 mm hex head wrench

• Rubber mallet

Step 2: Remove the (4) upper screws (circled

in red).

Step 4: Roll handle forward, gently tap outwards

using a rubber mallet then remove top half of

frame..

Step 5: Once top half is off, remove the lower

(4) screws, circled in red.

LOWER JOINTS REPLACEMENT

Step 1:

Note the orientation of the unit and

confirm the left and right lower joints.

Right

Step 3:

To get screw out, loosen the joint

(red arrow) and squeeze together (red circle).

CAUTION: When removing the top half of

frame, DO NOT over extend sensor wires.

Step 6: Using a rubber mallet, tap upward to

remove lower joints.

Left

Pg. 1 of 2

Page 1 LOWER JOINTS REPLACEMENT Tools Needed: Step 1: Note the orientation of the unit and • Phillips screwdriver or confirm the left and right lower joints. • 3 mm hex head wrench Right Left • Rubber mallet Step 3: To get screw out, loosen the joint Step 2: Remove the (4) upper screws (circled (red arrow) and squeeze together (red circle).
Page 2 Step 7: Replace the replacement lower joints. Step 8: Align the screw holes (lower) of the Make sure the lower joints are in a locked lower joints to the holes on the frame and position. install the (4) screws. Step 9: Install the top half of the frame to the Step 10: Align the screw holes (upper) of the lower joints.