– Is the failure repeatable?
– Has this configuration ever worked?
– If it has been working, what changes were made prior to it failing?
– Is this the original reported failure?
• Diagnostics version
– Type and version level
• Hardware configuration
– Print (print screen) configuration currently in use
– BIOS level
• Operating system software
– Type and version level
Notes: To eliminate confusion, identical systems are considered identical only if they:
1. Are the exact machine type and models
2. Have the same BIOS level
3. Have the same adapters/attachments in the same locations
4. Have the same address jumpers/terminators/cabling
5. Have the same software versions and levels
6. Have the same Diagnostic Diskettes (version)
7. Have the same configuration options set in the system
8. Have the same setup for the operating system control files
Comparing the configuration and software set-up between "working and non-working" systems will often
lead to problem resolution.
Symptom-to-FRU index
The Symptom-to-FRU index lists error symptoms and possible causes. The most likely cause is listed first.
Always begin with "Service checkout" on page 75. This index can also be used to help you decide which
FRUs to have available when servicing a computer. If you are unable to correct the problem using this
index, go to "Undetermined problems" on page 80.
Notes:
• The Symptom-to-FRU index is not specific to any machine type and are applicable to all Lenovo computers.
• If you have both an error message and an incorrect audio response, diagnose the error message first.
• If you cannot run the diagnostic tests or get a diagnostic error code when running a test, first diagnose the POST
error message you receive.
• If you did not receive any error message, look for a description of your error symptoms in the first part of this index.
Hard disk drive boot error
A hard disk drive boot error can have the following causes.
Error
The start-up drive is not in the boot sequence in
configuration.
No operating system installed on the boot drive.
76
Lenovo S200 Hardware Maintenance Manual
FRU/Action
Check the configuration and ensure the start-up drive is
in the boot sequence.
Install an operating system on the boot drive.