Advertisement
Quick Links
2CSYD0301N
EN
Usage manual
2 ACQUISITION AND
PROGRAMMING
To let the control unit acquire the remote control:
1.
Power the remote control by removing the isolating
protection of the battery (please refer to the section Battery
replacement for details about how to open the remote
control).
2.
On the control unit, activate the remote control acquisition
mode.
3.
Press any key on the remote control so that it can be
acquired by the control unit.
4.
Program the remote control (keys and LEDs).
Programming details are encompassed in the control unit installation
manual.
3 USAGE
IMPORTANT NOTE! As keys and LEDs (except LED 1) are
freely configurable, the function linked to each of them shall be
communicated to the user by the installer.
Each remote control can be configured in a different way.
When you press a key, the remote control sends the relevant
command to the control unit.
LED 1 indicates if the control unit replied.
Remote control
1 GENERAL DESCRIPTION
The Remote control is a portable device that enables to interact with
the control unit.
It encompasses 5 keys that can be configured and linked to the
functions related to the arming and disarming of the anti-intrusion
areas or to special functions such as burglary alarm, panic alarm, aid
alarm, operations or system status request.
The Braille characters enable an easy usage of the device also by
visually impaired people.
Through the configurable LEDs, it is possible to know the status of
the areas.
3.1
LEDs
LED 1 is a standard LED and cannot be configured. Signals provided
by LED 1 when any key is pressed are the following:
LED turns on green:
LED turns on red:
LED turns on after 1 sec:
LED turns on after 0.2 sec:
LEDs 2, 3, 4 and 5 can be separately configured and provide the
following indications:
LED turned off:
LED turns on green for 2
seconds:
LED turns on red for 2
seconds:
All LEDs turn on orange for 2
seconds:
When you receive an arming block signal, it is possible to force the
block by sending the command again.
2CSYD0301N
Full battery
Voltage of the battery lower than 2.7 V
The control unit does not reply
The control unit replied
1
The LED is not configured
Anti-intrusion area/s disarmed
Anti-intrusion area/s armed
Arming/disarming block on the control
unit
Advertisement
Related Manuals for ABB 2CSYD0301N
Summary of Contents for ABB 2CSYD0301N
- Page 1 1 GENERAL DESCRIPTION 2CSYD0301N Remote control Usage manual The Remote control is a portable device that enables to interact with the control unit. It encompasses 5 keys that can be configured and linked to the functions related to the arming and disarming of the anti-intrusion areas or to special functions such as burglary alarm, panic alarm, aid alarm, operations or system status request.
- Page 2 Low battery EC Declaration of Conformity Additional data provided by the manufacturer ABB S.p.A., with registered office in Milan - via Vittor Pisani 16, declares under its own responsibility that the device with product USAGE TEMPERATURE -5 … + 55 °C...