Table of Contents
Advertisement
Figure 34
1. Spring loaded idler pulley
2. Short hook end
7. Pull back on the spring-loaded idler pulley and install
the belt onto the spring-loaded idler pulley
Checking and Adjusting the
Blower Latch
Close the blower assembly to see if the latches are adjusted
correctly. Loosen or tighten the bolts so the latches firmly
hold the blower assembly against the mower deck, but can be
released by hand.
Figure 35
1. Latch
2. Bolt
Greasing the Idler Arm
Service Interval: Every 50 hours
Grease the bagger belt idler arm
3. Long hook end
(Figure
33).
3. Blower assembly
(Figure
36) every 50 hours.
Inspecting the Bagger
Service Interval: Every 100 hours
After the first 8 hours
Inspect the bagger attachment after the first eight hours of
operation, and 100 hours thereafter.
1. Disengage the PTO, move the motion control levers to
the N
-L
EUTRAL
brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Check the upper tube, lower tube, bagger hood, and
the blower assembly. Replace these parts if they are
cracked or broken.
4. Check the bags, bagger frame, and screen. Replace any
parts that are cracked or broken.
5. Tighten all nuts bolts and screws.
Inspecting the Mower Blades
1. Inspect the mower blades regularly and whenever a
blade strikes a foreign object.
2. If blades are badly worn or damaged, install new blades.
Refer to your machine Operator's Manual for complete
blade maintenance.
Installing the Mower Blades
In most mowing conditions, the standard high lift blades will
provide the best bagging performance.
The Toro Atomic blade is recommended for bagging leaves
in dry conditions. In dry dusty conditions, the medium lift
or low lift blades will reduce dust and dirt blowout while
providing effective bagging air flow.
22
Figure 36
position, and set the parking
OCKED
Advertisement
Table of Contents
