Advertisement
Quick Links
SD8/SD8PLUS
for sliding screen doors
MADE IN AUSTRALIA BY
Austral Lock
ILLUSTRATED FITTING INSTRUCTIONS
156mm
16mm
Door Cutout
IMPORTANT : If installing SD8 with a multipoint accessory
kit, be sure to follow the cylinder installation procedure
within the multipoint kit instructions.
3.
Assemble the cylinder through the lock so
the cylinder protrudes equally from both sides.
Note: The cylinder cam must rotate as
shown below. (cam turns towards front of door)
Insert the key and turn to locked position.
Insert #10 x 38mm cylinder screw & tighten.
Note: Test - beak should not depress.
Turn key to unlocked position and remove key.
5.
Spindle Selection
Break the spindle pair in two.
Select the correct spindle according to
diagram below:
'L' spindle is
used with 'L'
furniture plate
L
R
L
1.
The sticker on the rear of the lockbody is to
assist in easy installation. - Do not remove.
If the sticker has been broken or removed,
ensure that the rear slide is pushed
completely down before assembling the
lockbody into the door cutout.
lockbody
sticker
rear slide
cylinder
cylinder cam
6.
Spindle and Slide Assembly
Visually check if the interior furniture plate
(being fixed on the inside of the door), is
marked with an 'R' or 'L', and install the
corresponding 'R' or 'L' spindle. The remaining
spindle can be discarded.
Assemble the spindle, slide and retaining
plate as shown below.
'R' spindle is
used with 'R'
furniture plate
R
PLEASE TURN PAGE FOR INSTALLATION STEP 8.
Preparation
Cylinder Installation
beak
cylinder
screw
cam operation
Note: Spindle needs to
match the corresponding
'R' or 'L' furniture plate
Slide
Retaining
plate
2.
Lockbody installation
Insert the lock body into the door cutout.
Secure the lockbody with two #8 x 13mm
lockbody screws.
door cutout
4.
Exterior Furniture Preparation
Select the exterior furniture assembly to
be placed on the outside of your door, then
insert the two screw spiggots into the
exterior lever plate.
Install the exterior plug as shown.
screw
spiggots
7.
Furniture Installation
Place the exterior furniture assembly over the
cylinder and hold it against the door.
Secure both furniture assemblies together
using the two #8 x 32mm furniture assembly
screws.
Note: Ensure the
square drives on the lever
and spindle are guided into the lockbody.
Push the two plugs provided into the screw
holes in the interior furniture assembly.
Furniture
screws
(Pk0153) SD8 Instructions (A4) R2
lock body
lock body
screw
exterior
plug
Screw
plugs
Advertisement
Related Manuals for Gainsborough SD8
Summary of Contents for Gainsborough SD8
- Page 1 156mm lock body screw 16mm Door Cutout IMPORTANT : If installing SD8 with a multipoint accessory Exterior Furniture Preparation kit, be sure to follow the cylinder installation procedure within the multipoint kit instructions. Select the exterior furniture assembly to be placed on the outside of your door, then...
- Page 2 Note: Place the screws in the centre of the slots to allow for adjustment. Test that the strike plate engages the lock correctly and adjust if necessary. receiving channel SD8 - CARE & MAINTENANCE Installation The product must be installed according to the instructions included in the product packaging and the door should be apertured according to the door “cut-out”...