Advertisement
Quick Links
Advertisement
Related Manuals for EAT E-Flat
Summary of Contents for EAT E-Flat
- Page 1 EuroAudioteam, s.r.o. INSTRUCTIONS FOR USE EAT E-Flat...
- Page 2 Please take the time to read this manual carefully, to ensure that you obtain the ultimate performance from your EAT E-Flat turntable. The tips contained within will ensure that your Forte will remain as-new condition for many years to come!
- Page 3 EAT E-Flat Your contribution to environmental protection. Disposal of packaging material: Packaging protects the device from damage during the transportation. The packaging materials were chosen with the regard to the environmental protection and they are therefore recyclable. Disposal of old equipment:...
- Page 4 Controls, features, connections and parts of the turntable: 1 Sub Platter 2 Sub Platter shaft 3 Pulleys of the motors 4 Drive belt 5 Platter 6 Tightening disk – or record clamp 7 Plinth or chassis of the turntable 8 Tonearm 9 Cartridge 10 Tonearm pivot point 11 Isolation connector...
- Page 5 The device is shipped partially disassembled in order to avoid damage to sensitive parts. Please, double-check immediately after receiving it if the packaging and the device were not damaged during the transportation. If damaged please do not operate. Compare the data for the electrical connection on the type plate of the turntable with your network data.
- Page 8 Mounting of the Cartridge (9) to the Tonearm (8): If you purchased one of our EAT cartridges please install it to the flat carbon tonearm now. Install screws that are part of the cartridge box into the oval holes of the tonearm and fix it into the cartridge holes from the bottom side of the carbon tonearm.
- Page 9 or right. By turning the feet to the right, the chassis will raise; turning the feet to the left will lower the turntable. You can check the level by the levelling gauge if you have one. Setting of the vertical force on the pickup stylus. The value of the vertical force is recommended value of the cartridge.
- Page 10 With help of the Antiscating rider (14) you can adjust the position of the tonearm antiscating weight cca 45° For the vertical force of the stylus: up to 13mN - use position of the counterweight in Stuck Nr. 1 13-18mN – use position of the counterweight in Suck Nr. 2 18-25mN- use position of the counterweight in Stuck Nr.
- Page 11 The button will start to blink and after the reaching the right speed will light constantly. To stop the turntable you press button STNBY-STOP. As a safety precaution, always disconnect the record player from the mains power supply before maintenance! Technical specifications EAT E-Flat * Electronic speed change * 33.33/* 45.11 Speed variance ±0.09% Wow and flutter ±0.01%...
-
Page 12: Useful Tips
Modification or change to any part of the product by unauthorised persons release the manufacturer from any liability over and above the lawful rights of the customer. The information was correct at the time of EAT EuroAudioTeam is a Registered going to press. The manufacturer reserves the Trademark of Jozefina Lichtenegger.