Advertisement
Quick Links
Your new dryer
Intended Use
Congratulations - You have opted for a modern, high quality
J
only in the household;
domestic appliance of the Bosch brand. The condenser dryer is
J
only for drying textiles which have been
distinguished by its economical energy consumption.
washed with water.
Each dryer which leaves our factory is inspected thoroughly to
ensure that it functions properly and is in perfect condition.
If you have any questions, please do not hesitate to contact our
Do not leave children unattended
customer service.
near the dryer!
Keep pets away from the dryer!
Environmental disposal
Dispose of packaging in an environmentally friendly manner.
This appliance has been identified in accordance with the
ó
European directive 2002/96/EG on Waste Electrical and
Electronic Equipment - WEEE.
The directive specifies the framework for an EU wide valid return
and recycling of old appliances.
Contents
Page
Select additional
Status displays
Time
J
Preparation
2
function
remaining
J
Setting programmes
2
J
After drying
4
J
About the washing ...
5
Servicing and cleaning
6
J
J
Overview of programmes
7
J
Installation
8
J
Technical specifications
9
J
Optional accessories
9
J
What to do if ...
10
Safety instructions
11
J
Service displays
Container å
Empty condensation container.
Filter ç
Clean fluff filter and/or air cooler.
J C Buzzer
Select On/Off for acoustic signal at end of programme
Reduced temperature for sensitive textiles D, e.g. polyacrylic, polyamide, elastane, acetate,
J [ Low Heat
for longer drying time.
J e Reduced
Reducescreasing and extends anti crease phase when programme ends.
ironing
Preparation
For installation see page 8
Check
Never use a damaged dryer!
Notify customer service!
the dryer
With dry hands only!
Insert the
Take hold of the plug with dry
mains plug
Condensation container
hands only!
Sort and put in the washing
Take all objects out of the pockets.
Look out for cigarette lighters!
The drum must be empty before it is loaded!
See overview of programmes on page 7.
Selecting + setting programme
1
Select drying programme ...
2
... and adjust
Programme selector
All buttons are sensitive,
a gentle tap is adequate!
3
Select Start button
Maintenance flap
Draining the condensation
Drying
Empty container after each drying operation!
1.
Pull out the container and keep in a horizontal position.
2.
Pour out the condensation.
3.
Insert the container until it locks into position.
Cleaning the fluff filter
1.
Open door, pull out filter and open.
2.
Remove fluff (run hand over filter).
Door handle
3.
Close filter, re insert and close door.
Rinse extremely soiled or blocked filters with warm water and dry thoroughly.
Drum
Switching off the dryer
Control panel
Set programme selector to 0 (Off).
Do not leave damp washing in the dryer!
Removing washing
The automatic anti crease function causes the drum to move at specific intervals, the washing remains
loose and fluffy for an hour (two hours if the e Reduced ironing function is also selected - depending
on model).
Programme end
as soon as the light comes on
Topping up or removing washing
1.
Open door, the drying process is terminated.
2.
Top up or remove washing and close door.
3.
Cooling grille
If required, reselect programme and additional functions.
4.
Select l Start/Stop button.
Drying
Drum and door may be hot.
About the washing ...
Servicing and cleaning
Dryer housing, control panel, cooling grille
Identifying textiles
Rub with a soft, damp cloth.
Follow care information of the manufacturer!
Do not use any caustic cleaning agents/solvents.
Immediately remove washing and cleaning agent residue.
Dry at normal temperature.
During drying, water may occasionally collect between the window and the seal.
This does not adversely affect the function of your dryer in any way!
Dry at low temperature -> also select [ Low Heat.
Do not dry by machine.
Air cooler
Do not dry the following textiles in the dryer.
Leave the dryer to cool down.
Airtight textiles (e.g. rubberised).
Residual water may escape, place an absorbent cloth under
Delicate fabrics (silk, synthetic curtains) -> anti creasing!
the maintenance flap.
1. Unlock the maintenance flap.
Dripping wet washing -> high energy consumption!
2. Completely open maintenance flap.
Oil contaminated washing.
Drying tips
For uniform drying result, sort the washing according to fabric type and drying
3. Screw both locking levers towards each other.
programme.
4. Pull out the air cooler
Close zips, hooks and eyelets, button up quilt covers, tie fabric belts, apron
strings, etc.
Do not damage the air cooler!
Do not overdry the washing -> risk of creasing! Leave the washing to air.
Clean with warm water only; do not use hard/sharp
edged objects!
Do not iron the washing immediately after drying, fold up the washing for a while
-> residual moisture will then be distributed evenly.
5. Clean the air cooler completely, drain thoroughly.
Knitted textiles (e.g. T shirts, knitted underwear) often shrink when dried for the
6. Clean the seals.
first time -> Do not use the Ç: Very Dry programme.
7. Re insert the air cooler, handle at the bottom!
The drying of starched washing should be limited -> Starch leaves a coating
8. Unscrew both locking levers.
which impairs drying.
9. Close the maintenance flap until it locks into position.
Use the time programme for a small load.
Protection of the environment/Conservation of energy
Before drying, thoroughly spin the washing in the washing machine ->
Higher spin speeds reduce the drying time and lower the energy consumption;
Moisture sensor
also spin easy care washing.
Use the maximum recommended load, but do not exceed -> Page 7, Overview
The dryer is equipped with moisture sensors made of stainless steel. The
of programmes".
moisture level of the washing is measured with the moisture sensors. After a
longer operating time, a fine layer of limescale may form on the moisture sensors.
Ensure that the room is well ventilated during the drying process.
1. Open the door.
Clean the fluff filter after each drying process -> Page 4.
2. Clean the moisture sensor using a damp sponge with a rough
Keep the air cooler clean -> Page 6 Servicing and cleaning".
surface (scouring pad).
Ensure that the cooling air flow is not obstructed -> Do not block or seal the
cooling grille.
Do not use steel wool or abrasive materials.
Appliance must be
switched off
3-4 times a year or if ç Filter flashes continuously
after the fluff filter has been cleaned.
Advertisement
Related Manuals for Bosch WTE86302AU
Summary of Contents for Bosch WTE86302AU
- Page 1 Check Pour out the condensation. Never use a damaged dryer! domestic appliance of the Bosch brand. The condenser dryer is Dryer housing, control panel, cooling grille only for drying textiles which have been Identifying textiles Notify customer service! the dryer Insert the container until it locks into position.
- Page 2 Technical specifications Installation What to do if ... Safety instructions Dimensions (D x W x H) 60 x 60 x 85 cm (height adjustable) Repairs may be carried out by customer service or authorised technicians only! Included in standard delivery: dryer, operating and installation instructions. Emergency Immediately pull out mains plug or interrupt fuse.