Table of Contents
Advertisement
Available languages
Available languages
Quick Links
MONO POWER AMPLIFIER
AMPLIFICATEUR DE PUISSANCE MONO
Owner's Manual
GM-7100M
Mode d'emploi
PIONEER CORPORATION
4-1, MEGURO 1-CHOME, MEGURO-KU, TOKYO 153-8654, JAPAN
PIONEER ELECTRONICS (USA) INC.
P.O. Box 1540, Long Beach, California 90801-1540, U.S.A.
TEL: (800) 421-1404
PIONEER EUROPE NV
Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium
TEL: (0) 3/570.05.11
PIONEER ELECTRONICS ASIACENTRE PTE. LTD.
253 Alexandra Road, #04-01, Singapore 159936
TEL: 65-6472-7555
PIONEER ELECTRONICS AUSTRALIA PTY. LTD.
178-184 Boundary Road, Braeside, Victoria 3195, Australia
TEL: (03) 9586-6300
Published by Pioneer Corporation.
Copyright © 2004 by Pioneer Corporation.
PIONEER ELECTRONICS OF CANADA, INC.
All rights reserved.
300 Allstate Parkway, Markham, Ontario L3R OP2, Canada
TEL: 1-877-283-5901
Publication de Pioneer Corporation.
Copyright © 2004 Pioneer Corporation.
PIONEER ELECTRONICS DE MEXICO, S.A. de C.V.
Tous droits de reproduction et de traduction
Blvd.Manuel Avila Camacho 138 10 piso
réservés.
Col.Lomas de Chapultepec, Mexico, D.F. 11000
TEL: 55-9178-4270
Printed in China
Imprimé en Chine
<KMINX> <04I00000>
<CRD3922-A/U> UC
Before Using This Product
Thank you for purchasing this PIONEER
After-sales service for Pioneer
product. It is designed to give you many
products
years of enjoyment.
PIONEER SUGGESTS USING A PRO-
FESSIONAL INSTALLER DUE TO THE
Please contact the dealer or distributor from where
COMPLEXITY OF THIS PRODUCT.
you purchased the product for its after-sales ser-
Please read all instructions and WARN-
vice (including warranty conditions) or any other
information. In case the necessary information is
INGS in this manual before attempting
not available, please contact the companies listed
operation. Should you have any questions,
below:
contact your nearest Pioneer authorized
Please do not ship your product to the companies
dealer or installation specialist.
at the addresses listed below for repair without
advance contact.
Information to User
7 U.S.A.
Alteration or modifications carried out
Pioneer Electronics (USA) Inc.
without appropriate authorization may
CUSTOMER SUPPORT DIVISION
invalidate the user's right to operate the
P.O. Box 1760
equipment.
Long Beach, CA 90801-1760
800-421-1404
Important
7 CANADA
The serial number of this amplifier is writ-
Pioneer Electronics of Canada, Inc.
ten on the bottom of the unit. For your
CUSTOMER SATISFACTION
own security and convenience, write it
DEPARTMENT
down on the enclosed warranty card. Keep
300 Allstate Parkway
the card handy for future reference.
Markham, Ontario L3R OP2
1-877-283-5901
For warranty information please see the Limited
Warranty sheet included with your product.
<ENGLISH>
Product registration
WARNING
Visit us at the following site:
• Handling the cord on this product or cords associ-
ated with accessories sold with the product will
expose you to lead, a chemical known to the State
of California and other governmental entities to
cause cancer and birth defects or other reproduc-
tive harm. Wash hands after handling.
1 Register your product. We will keep the details of
• Always use the special red battery and ground
your purchase on file to help you refer to this
wire [RD-223], which is sold separately. Connect
information in the event of an insurance claim
the battery wire directly to the car battery positive
such as loss or theft.
terminal (+) and the ground wire to the car body.
2 Receive updates on the latest products and tech-
• Do not touch the amplifier with wet hands.
nologies.
Otherwise you may get an electric shock. Also, do
3 Download owner's manuals, order product cata-
not touch the amplifier when it is wet.
logues, research new products, and much more.
• For traffic safety and to maintain safe driving
conditions, keep the volume low enough so that
About This Product
you can still hear normal traffic sound.
• Check the connections of the power supply and
subwoofer if the fuse of the separately sold bat-
This product is an amplifier for the sub-
tery wire or the amplifier fuse blows. Detect the
woofer. If both L (left) and R (right) chan-
cause and solve the problem, then replace the fuse
nels are connected to the RCA input of this
with another one of the same size and rating.
product, output is mixed because this prod-
• To prevent malfunction of the amplifier and sub-
uct is a mono amplifier.
woofer, the protective circuit will cut the power
supply to the amplifier (sound will stop) when an
abnormal condition occurs. In such a case, switch
CAUTION
the power to the system OFF and check the
connection of the power supply and subwoofer.
Never replace the fuse with one of greater
Detect the cause and solve the problem.
value or rating than the original fuse. Use
• Contact the dealer if you cannot detect the cause.
of an improper fuse could result in over-
• To prevent an electric shock or short-circuit
heating and smoke and could cause dam-
during connection and installation, be sure to
age to the product and injury including
disconnect the negative (–) terminal of the battery
burns.
beforehand.
• Confirm that no parts are behind the panel when
drilling a hole for installation of the amplifier. Be
sure to protect all cables and important equipment
such as fuel lines, brake lines and the electrical
wiring from damage.
• DO NOT allow amplifier to come into contact
with liquids due to, for example, the location
where the amplifier is installed. Electrical shock
could result. Also, amplifier and speaker damage,
smoke, and overheating could result from contact
with liquids. In addition, the amplifier surface and
the surface of any attached speakers could become
hot to the touch and minor burns could result.
Advertisement
Table of Contents
Related Manuals for Pioneer GM-7100M
Summary of Contents for Pioneer GM-7100M
- Page 1 300 Allstate Parkway, Markham, Ontario L3R OP2, Canada TEL: 1-877-283-5901 Publication de Pioneer Corporation. Copyright © 2004 Pioneer Corporation. PIONEER ELECTRONICS DE MEXICO, S.A. de C.V. Tous droits de reproduction et de traduction Blvd.Manuel Avila Camacho 138 10 piso réservés.
-
Page 2: Setting The Unit
(standard output of 500 mV), set to body. the NORMAL position. When using with an RCA equipped Pioneer car stereo with max. output of 4 V or more, adjust level to match the car stereo output level. • If you hear too much noise when using the speaker input terminals, turn the gain control counter-clockwise. -
Page 3: Installation
Connecting the Unit <ENGLISH> Installation Connecting the Speaker wires Using the Speaker Input Connect the speaker leads according to the Connect the car stereo speaker output • Do not install in: figures shown below. wires to the amplifier using the supplied speaker input connector. -
Page 4: Avant D'utiliser Cet Appareil
Avant d’utiliser cet appareil Nous vous remercions d’avoir porté votre Enregistrement du produit Service après-vente pour un choix sur un appareil PIONEER. Il a été produit Pioneer conçu et fabriqué pour vous apporter de Rendez-nous visite sur le site suivant: nombreuses années de satisfaction. -
Page 5: Raccordement De L'appareil
Raccordement de l’appareil Schéma de raccordement PRÉCAUTION • Pour éviter tout risque de court-circuit ou • Veillez à ce qu’aucun câble ne soit en court- d’endommager cet appareil, débranchez le câble circuit, faute de quoi le circuit de protection Passe-câble relié... -
Page 6: Caractéristiques Techniques
Impédance de charge ... 4 Ω (2 — 8 Ω permis) tiones, póngase en contacto con su Réponse en fréquence ... 10 — 240 Hz (+0 dB, –3 dB) revendedor autorizado de Pioneer o con un Rapport signal/bruit ... 100 dB (Réseau IHF-A) especialista de instalación más próximo. -
Page 7: Ajuste De Esta Unidad
500 mV), ajuste a la posición normal. deslizamiento de los asientos. Cuando use con un estéreo de automóvil Pioneer equipado con RCA con una salida máxima de 4 V o más, ajuste el nivel para adecuarse al nivel de salida del estéreo del automóvil. -
Page 8: Instalación
Conexión de la unidad <ESPAÑOL> Instalación Conexión de los cables de Uso de la entrada de altavoz PRECAUCION altavoces Conecte los hilos de la salida de altavoz • No lo instale en: del estéreo de automóvil al amplificador —Donde podría lesionar al conductor o a los Conecte los cables de altavoz según los usando el conector de entrada de altavoz diagramas mostrados abajo.