SERVICE MANUAL MICRO COMPONENT SYSTEM MB107 2004 UX-H9 TIMER TIMER SET ON/OFF STANDBY/ON INTRO /RDS SEARCH RANDOM SLEEP STANDBY/ON REMAIN REPEAT /RDS MODE PROGRAM ST/MONO VOLUME TUNER TAPE /BAND BEAT CUT STANDBY MICRO COMPONENT SYSTEM UX-H9 DISPLAY /CLOCK SET SOUND...
Page 2
SPECIFICATION 10 W (5 W + 5 W) at 4 Ω (10% THD) Amplifier Section Output Power (IEC 268-3) CA-UXH9 4 Ω - 16 Ω Speakers/Impedance Tuner FM tuning range 87.50 MHz-108.00 MHz AM (MW) tuning range 522 kHz-1 629 kHz CD player Dynamic range 60 dB...
SECTION 1 PRECAUTION Safety Precautions (1) This design of this product contains special hardware and voltmeter. many circuits and components specially for safety purpos- Move the resistor connection to each exposed metal es. For continued protection, no changes should be made part, particularly any exposed metal part having a return to the original design unless authorized in writing by the path to the chassis, and measure the AC voltage across...
Page 4
1.5 Safety Precautions (U.K only) (1) This design of this product contains special hardware and many circuits and components specially for safety purposes. For con- tinued protection, no changes should be made to the original design unless authorized in writing by the manufacturer. Replace- ment parts must be identical to those used in the original circuits.
Page 5
Preventing static electricity Electrostatic discharge (ESD), which occurs when static electricity stored in the body, fabric, etc. is discharged, can destroy the laser diode in the traverse unit (optical pickup). Take care to prevent this when performing repairs. 1.6.1 Grounding to prevent damage by static electricity Static electricity in the work area can destroy the optical pickup (laser diode) in devices such as CD players.
Page 6
Important for laser products 5.CAUTION : If safety switches malfunction, the laser is able 1.CLASS 1 LASER PRODUCT to function. 2.DANGER : Invisible laser radiation when open and inter 6.CAUTION : Use of controls, adjustments or performance of lock failed or defeated. Avoid direct exposure to beam. procedures other than those specified herein may result in 3.CAUTION : There are no serviceable parts inside the hazardous radiation exposure.
SECTION 3 DISASSEMBLY Main body 3.1.1 Removing the Front panel assembly (See Fig.1 ~ 5) (1) Remove the two screws A and the two screws B on the Front panel assembly back of the body. (2) Remove the four screws C on each side of the body. (3) Remove the two screws D on the bottom of the body.
Page 9
3.1.2 Removing the Main board (See Fig.6 , 7) • Prior to performing the following procedure, remove the front Front panel panel assembly. assembly CD mechanism (1) Disconnect the wire from all connectors on the main board. CN260 assembly (2) Remove the two screws E and release the joint b. CN602 CN601 CN301...
Page 10
3.1.3 Removing the CD mechanism assembly and the Switch board (See Fig.8 ~ 10) • Prior to performing the following procedure, remove the front Open switch panel assembly and the main board. connecter Front panel Band (1) Cut off the four bands setting the wires. CD mechanism assembly (2) Disconnect the wire from connector on the CD open switch...
Page 11
3.1.4 Removing the CD mechanism board (See Fig.11 ~ 13) • Prior to performing the following procedure, remove the front panel assembly, the main board and the CD mechanism assembly. (1) Disconnect connector on the CD mechanism. Front panel (2) Remove the four screws H on the CD mechanism assembly.
Page 12
3.1.5 Removing the Headphone board (See Fig.14) • Prior to performing the following procedure, remove the front panel assembly, the main board and the CD mechanism assembly. Head phones board (1) Remove the screw L on the bracket and pull out the headphone board.
Page 13
3.1.8 Removing the transformer board (See Fig.17,18) • Prior to performing the following procedure, remove the front Solder point panel assembly. (1) From the rear cover assembly, remove the screw Q Trans borad attaching the transformer board. (2) Remove the four screws R attaching the transformer. (3) Remove the two screws S setting the power cord.
Reference output Speaker output 0 dB(1V)/ 4 Ω H. Phone output -10 dB(0.1V) 32Ω 4.1.2 CD section Test disc: JVC standard disc 4.1.3 Test tape JVC standard test tape 4.1.4 Measuring instruments Radio section FM 1 kHz, 22.5 kHz deviation FM STEREO : 1kHz, 67.5 kHz deviation...
Page 15
4.1.5 Cassette Amplifier Section Standard value Item Measuring Condition Check and adjustment procedure Adjusting part Head azimuth Test tape: 1. Play back the test tape (8 kHz). Output level: Head azimuth adjustment 8 kHz 2. Adjust the head azimuth adjusting screw so that Within 2 dB of adjusting Signal output...
Page 16
4.1.6 Tuner Section Check and adjustment procedure Standard value Adjusting part Item Measuring Condition AM IF adjustment Signal input: 1.Set the intermediate frequency sweep generator to T201 Loop ANTENNA AM 450 kHz. See Fig 3-3 Signal output: 2.Adjust the T201 for maximum and center output. U201 PIN 16 1.Set the TUNER at 531 kHz adjust T202 until the AM tracking...
SECTION 5 TROUBLESHOOTING Circuit Symptom Cause and Remedy General No sound Speakers are not connected: Check the speaker connection. Wrong function is selected: Set switch to the proper position. Defective volume control: Set the volume control to a proper sound level. Defective the Headphone jack: Replace the headphone jack.
Page 20
VICTOR COMPANY OF JAPAN, LIMITED AV & MULTIMEDIA COMPANY AUDIO/VIDEO SYSTEMS CATEGORY 10-1,1chome,Ohwatari-machi,Maebashi-city,371-8543,Japan (No.MB107) Printed in Japan...
Page 21
SCHEMATIC DIAGRAMS MICRO COMPONENT SYSTEM UX-H9 CD-ROM No.SML200401 TIMER TIMER SET ON/OFF STANDBY/ON INTRO /RDS SEARCH RANDOM SLEEP STANDBY/ON REMAIN REPEAT /RDS MODE PROGRAM ST/MONO VOLUME TUNER TAPE /BAND BEAT CUT STANDBY MICRO COMPONENT SYSTEM UX-H9 DISPLAY /CLOCK SET SOUND...
Page 22
In regard with component parts appearing on the silk-screen printed side (parts side) of the PWB diagrams, the parts that are printed over with black such as the resistor ( diode ( ) and ICP ( ) or identified by the " " mark nearby are critical for safety. (This regulation does not correspond to J and C version.)
Page 24
Standard schematic diagrams Power supply section Parts are safety assurance parts. When replacing those parts make sure to use the specified one.
Page 25
Amp section Parts are safety assurance parts. When replacing those parts make sure to use the specified one.
Page 36
VICTOR COMPANY OF JAPAN, LIMITED AV & MULTIMEDIA COMPANY AUDIO/VIDEO SYSTEMS CATEGORY 10-1,1chome,Ohwatari-machi,Maebashi-city,371-8543,Japan Printed in Japan (No.MB107SCH)
PARTS LIST [ UX-H9 ] * All printed circuit boards and its assemblies are not available as service parts. Area suffix E ----------- Continental Europe EN ------------ Northern Europe - Contents - 3 - 2 Exploded view of general assembly and parts list (Block No.M1) 3 - 5 Electrical parts list (Block No.01~05)
Page 38
Exploded view of general assmbly and parts list Block No. Phone board Key board LED board CN704 Display board...
Page 39
Main board CN704 play board CD board F902 F901 Power board...
Page 40
Door OW36-00010-01 CASS DOOR SPRING OW43-00010-01 CASS DOOR LENS OW66-00010-01 CASS DOOR OW48-04200-04 CASS DOOR BKT OW43-00010-05 DISPLAY LENS PMMA OW55-30000-00 JVC BADGE OW60-00010-01 FRONT CABINET OW39-04200-05 PANEL FIXING Plate(x6) OW53-00010-01 POWER KNOB OW42-00010-00 PVC SHEET OW53-00010-02 VOLUME KNOB OW94-04200-00...
Electrical parts list Main board Symbol No. Part No. Part Name Description Local Block No. [0][1][0][0] C211 OW06-16336-02 E CAPACITOR 33mF 16V Symbol No. Part No. Part Name Description Local C213 OW05-03151-03T C CAPACITOR 150pF C214 OW05-03222-06T C CAPACITOR 2200pF C215 OW05-03822-06T C CAPACITOR...
Page 42
Symbol No. Part No. Part Name Description Local Symbol No. Part No. Part Name Description Local C320 OW06-50104-03 E CAPACITOR 0.1mF 50V C815 OW05-02154-10 M CAPACITOR 0.15mF C321 OW05-03392-06T C CAPACITOR 0.0039mF C816 OW05-02154-10 M CAPACITOR 0.15mF C322 OW05-03392-06T C CAPACITOR 0.0039mF C817 OW05-03104-06T...
Page 43
Symbol No. Part No. Part Name Description Local Symbol No. Part No. Part Name Description Local R270 OW07-25102-60K C RESISTOR 1K 1/16W R361 OW07-25333-60K C RESISTOR 33K 1/16W R271 OW07-25103-60K C RESISTOR 10K 1/16W R362 OW07-25104-60K C RESISTOR 100K 1/16W R272 OW07-25472-60K C RESISTOR...
Page 44
CD board Symbol No. Part No. Part Name Description Local Block No. [0][2][0][0] CF204 OW09-50450-00J CER. FILTER 450HK2 CF205 OW09-50107-07J CER. DIS. JT10.7MG82 Symbol No. Part No. Part Name Description Local CN201 OW12-00007-21 FM ANT SOCKET 75TC-103 CN202 OW20-12020-01K 2PIN HEADER P=2.5mm CN260 OW20-11060-02...
Symbol No. Part No. Part Name Description Local Symbol No. Part No. Part Name Description Local C795 OW05-07103-00A C CAPACITOR 0.01mF D902 IN4001 FR DIODE OW02-04001-00 D903 IN4001 FR DIODE OW02-04001-00 R701 OW07-15104-50T C RESISTOR 100K 1/8W D904 IN4001 FR DIODE OW02-04001-00 R702 OW07-15104-50T...
Symbol No. Part No. Part Name Description Local Symbol No. Part No. Part Name Description Local D104 1SS-133TP FR DIODE OW02-00133-00 L102 OW08-04344-40 FERRITE COIL D105 ELT-3142D OW02-30022-02E L103 OW08-04344-40 FERRITE COIL C101 OW06-06108-01 E CAPACITOR 1000mF 6.3V J101 OW07-15222-50T C RESISTOR 2.2K 1/8W C102...
Packing materials and accessories parts list Block No. A2,A8,A10 A3,A4 A6,A7 3-12...
Page 49
5W 4ohm(x2) OW23-04910-02 AM LOOP ANT OW88-00009-01 INST BOOK GER FRE DUT SWE FIN DAN OW88-00009-03 INST BOOK GER FRE SPA ITA OW88-00009-06 WARRANTY CARD OWV-RE-JVC REMOTE CONTROL OW81-01000-01 TRBLE CUSHION OW89-09023-36 PROTECT CD BOARD ------------ BATTERY (x2) OW87-00009-01 RATING LABEL...