Page 1
B53-0001-00 ( N ) 2139 CD mechanism operation description is not in this sarvice manual. CD mechanism extension cord : WO5-0618-00 Please, refer to sarvice manual X92-4030-0x (B51-7867-00). Panel assy Front glass (A64-2872-02): KDC-3023R (B10-4341-01): KDC-3023R Escutcheon (B07-3001-02) (A64-2875-02): KDC-4024/V/Y/YV (B10-4344-01): KDC-4024/V/Y/YV...
Page 2
3 7 6 3 1 5 1 5 0 FM(J,K) : 1800mV FM+B FM(E) : 1372mV IC10 Q502 Q223,224 AM(J,K) : 600mV CD : 3600mV AM(E) : 855mV CH : 3600mV FM AGC FM AGC OUT MUTE AM+B Q501 AM AGC POWER IC AM AGC OUT TUNER,MPX &...
KDC-3023R,4024/V/Y/YV MICROCOMPUTER'S TERMINAL DESCRIPTION 3 7 63 1515 0 SYSTEM MICROCOMPUTER uPD780058GC502 (X25 : IC1) Pin No. Name Description Processing Operation TDF DET Panel detection H:Panel detached L:Panel attached H:Eject is completed 8EJE SW Except 8cm CD model:always output L...
Page 5
KDC-3023R,4024/V/Y/YV MICROCOMPUTER'S TERMINAL DESCRIPTION 3 7 63 1515 0 Pin No. Name Description Processing Operation B.U-DET Back up detection terminal H:power down L:B.U. on ACC-DET ACC detection terminal H:ACC OFF L:ACC ON Power supply IC SW1 control 0 BA4911 SW1...
Page 7
KDC-3023R,4024/V/Y/YV MICROCOMPUTER'S TERMINAL DESCRIPTION 3 7 63 1515 0 Pin No. Name Description Processing Operation Main clock output terminal DVSS2 Ground lines for digital circuit XSUB1 When external DAC,external clock input terminal XSUB2 TEST1 Test port 1 Normal operation is H fixed...
KDC-3023R,4024/V/Y/YV ADJUSTMENT 3 7 63 1515 0 1-3. Adjustment of FM_ANT&RF Coil 1. IC10 (TDA7513) -The Tuner adjustment method Voltage Check Point : S_METER-Check Land (PWB • When IC10 and its circumference are fixed, according to the Side_B, around W572) following order, it readjusts if needed.
KDC-3023R,4024/V/Y/YV ADJUSTMENT 3 7 63 1515 0 2.IC10 (TDA7513) Replacement-Parts vs Adjustment Item Table • When the parts in the following tables are exchanged, please readjust according to a table. • When other parts are exchanged, please perform only a check of operation. There is no necessity for readjustment.
PC BOARD (COMPONENT SIDE VIEW) 3 7 63 1515 0 X32-5380-00 (J74-1485-12) L 13942296513 X32-5380-00 Ref. No address u163 Refer to the schematic diagram for the values of resistors and capacitors.
Page 11
PC BOARD (FOIL SIDE VIEW) 3 7 63 1515 0 X32-5380-00 (J74-1485-12) B/TE VREF VDET LDON A/TE TRCRS REFNV TRK IN TRK OUT D/ARF NRFDET FCS UP GCTL FCS DOWN VREF2 D.GND BU.5V D.OUT SLED IN 12EJE /EJECT SLED OUT DATA /CLK /LOAD...
Page 12
PC BOARD (FOIL SIDE VIEW) 3 7 63 1515 0 L 13942296513 X25-961x-xx u163 Ref. No address Ref. No address Ref. No address Ref. No address IC12 Q251 Q252 Q101 Q253 Q102 Q501 Q201 Q502 IC10 Q223 Q503 IC11 Q224 Refer to the schematic diagram for the values of resistors and capacitors.
Page 13
PC BOARD 3 7 63 1515 0 (COMPONENT SIDE VIEW) (FOIL SIDE VIEW) X16-1472-7x X16-1472-7x (J74-1287-22) (J74-1287-22) SW5V REMO DATAS L-CLK L-CE DATAL WL+B LRES IGND L 13942296513 u163 X16-1472-7x Ref. No address Refer to the schematic diagram for the values of resistors and capacitors.
Page 16
J4 TOP VIEW ∗ DATA H CHCON D GND 3 7 63 1515 0 REAR REQ C DATA C A GND MUTE REQ H ∗ ∗ (X25-961x-xx) C227 C228 680P 680P D GND R227 R228 Q223 Q224 ∗ MUTE ∗ ∗...
Page 17
3 7 63 1515 0 E2P-ROM IC12 ∗ 3.3K Q251 5.0V 1/2W SURGE W158 DETECTOR ∗ D252 R258 MUTE 0.01 A. C. C 0.01 DETECTOR ∗ 5.0V B. U. ∗ DETECTOR MUTE LOGIC ∗ 100K 100K POWER AMPLIFIRE L101 4.7uH CF54 ∗...
Page 18
10u50 D504-506 ∗ R145 (X25-961X-XX) 2.2K UNIT C51,529, C227,228,404, MODEL C D E F C106 NAME 557,558,589 528,590,592 SERBOGND KDC-3023R (M) 0-21 1000P R101 D102 KDC-4024 (E) SERBO+B 2-70 1000P KDC-4024Y (E) MO SW ∗ Q101 KDC-4024V (E) LO/EJ 2-71...
Page 20
• DC voltages are as measured with a high impedance voltmeter. Values may vary slightly due to variations between individual instruments or/and units. : LC75883E : RS-171 (X16-1472-7X) : DTA114EUA MODEL NAME UNIT No. Q2,3 : 2SC4081 KDC-3023R (M) D1-13,20 : B30-1605-05 KDC-4024 (E) 2-70 B38-1083-05 D17,18 : B30-1564-05 or KDC-4024Y (E) B30-1642-05...
157 (mm) 6-3/16 (in) Weight 3.1lbs (1.4kg) 3.1lbs (1.4kg) KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice. KENWOOD CORPORATION 2967-3, Ishikawa-machi, Hachioji-shi, Tokyo 192-8525, Japan KENWOOD ELECTRONICS ITALIA S.p.A. KENWOOD USA CORPORATION Via G.